Follow these steps to install the software: 1. Insert the JBLCOM disk into either drive A or drive B. 2. From the Windows Program Manager, click File from the menu bar and select Run. 3. In the Command Line text box type in a:setup, or b:setup depending upon in which drive you have placed the JBLCOM disk. 4. Click on the OK button. 5. Click on the Continue button to accept the default directory. A program group will be automatically created in the Program Manager. To run the software, click on the icon labeled JBLCOM. The �rst time the software is run, click Setup from the menu bar to specify the COM port you will be using to communicate with the STC-1. This COM port setting will be saved until the next time you change it.
2.1 Preparing the STC-1 for Communication
1. Plug the RJ-11 (telephone) plug into the STC-1�s communication port. 2. Make sure the other end of the cable is plugged into the DB-9 (9 pin) connector provided, and then plug the DB-9 into the correct COM port on your PC. If your COM port uses a DB-25 connector, use the 9-to-25 pin adapter provided. 3. Enter the Program Mode on the STC-1 and press the Computer Link button. As long as the STC-1 is in the computer link mode, the Computer Link button will be �reversed� and the unit will be ready to send or receive data. To exit this mode, simply touch any area of the STC-1�s screen. NOTE: The STC-1 CANNOT power-down automatically when in the computer link mode. If left in this mode for an extended period of time, the unit�s batteries will become completely discharged. For this reason it is recommended that when communications are performed to the STC-1, the STC-1 is running off of the AC adapter.
